All Projects

Drill new well and seal old well 102005

Reconstruct well to address groundwater under the direct influence of surface water

Seal two unused wells (unique well numbers 762655 and 762666)

Construct a new well that is out of a flood plain to higher ground.

Connect to the City of Lamberton water supply

Reconstruct, redrill, rehabilitate well 402043 and install a screen below the casing to the bottom of well for pump protection.

Install treatment. Add filtration, tank and monitoring equipment.

Drill a new well

Extend well casing for up to two wells and make repairs

Drill new well

Seal irrigation well 436711 and extend casing on well 458529

Investigate 1970 well integrity and disinfection of well

Purchase and install generator

Purchase and connect a portable diesel generator as a back up for if power fails at Well #6

Install security cameras at the North Buffalo well field (Moorhead Well 11), unique well No 511085, Duct plowing and boring, innerduct and fiber optic cable installed between two well houses, and install ethernet switches to facilitate communication betwe

Direct connection of the city's generator to the city's wellhouse. Install 400 amp. 3 phase automatic transfer switch.

Drill a new well to improve pressure in the system.

Complete electrical work and install concrete pad for generator.

Seal two wells A-10; 731125 and B-1; 796420

Install arsenic removal system

Purchase and install flow meter and associated equipment/programming and port; Excavate, install conduit, backfill and landscape

Install security fence and lockable gate around well house number 3

Rewire 6 wells generator plugs; Install new 100 amp wire generator, receptacles and wire system to manual transfer switch

Seal two wells

Purchase and install backup generator and equipment for well and reservoir

Upgrade SCADA to ensure safety and security for wells

Remove underground 10,000 gallon fuel oil tank to protect wells within the DWSMA

Seal municipal well #2 and remove pipe and pump so it will not be a dead line entry to pressure tank.

Provide second half of rent payment to landowner to allow city to implement nitrogen BMPs on field. Planting custom seed rye to scavenge up the residual nitrogen in the soil to keep it from getting into groundwater.

Irrigate its clarified effluent from Lime storage pond #6 instead of discharging to Mississippi River

Seal and grout 4 wells

Drill and install 4 above grade monitoring wells.

Minnesota Department of Health has been collaborating with cities and other community water suppliers since 1993 to develop and implement source water protection plans.  Support from the Clean Water Legacy expands and accelerates the number of water suppliers that can be assisted each year in undertaking protection planning and implementation activities. 

Install a 25 kilowatt Hanco diesel stand by generator at reservoir 8

Removal of septic tank and drain field. System get hooked in City sewer.

Install a well submersible level transducer and solar panel

Install standby power generator for groundwater production wells

Installation of security system at 2 Wellhouses

Purchase and installation of electronic magnetic meter and static water level indicators