All Projects

Replace door and remove windows to well house.

Design mitigation plan for floor drains that are connected to the storm sewer that discharge to a gravel pocket. Post a "No Dumping - clean water only" sign within the Inner Wellhead Management Zone

Purchase and install emergency backup generator

Educate property lake association owners, conduct well inventory and conduct lake and well sampling

Investigate well integrity with camera, measure well casing and disinfection of well.

Seal well 694785

Install membrane filtration

Drill new well and seal old well 102005

Reconstruct well to address groundwater under the direct influence of surface water

Seal two unused wells (unique well numbers 762655 and 762666)

Construct a new well that is out of a flood plain to higher ground.

Connect to the City of Lamberton water supply

Reconstruct, redrill, rehabilitate well 402043 and install a screen below the casing to the bottom of well for pump protection.

Install treatment. Add filtration, tank and monitoring equipment.

Drill a new well

Extend well casing for up to two wells and make repairs

Drill new well

Seal irrigation well 436711 and extend casing on well 458529

Investigate 1970 well integrity and disinfection of well

Purchase and install generator

Purchase and connect a portable diesel generator as a back up for if power fails at Well #6

Install security cameras at the North Buffalo well field (Moorhead Well 11), unique well No 511085, Duct plowing and boring, innerduct and fiber optic cable installed between two well houses, and install ethernet switches to facilitate communication betwe

Direct connection of the city's generator to the city's wellhouse. Install 400 amp. 3 phase automatic transfer switch.

Drill a new well to improve pressure in the system.

Complete electrical work and install concrete pad for generator.

Seal two wells A-10; 731125 and B-1; 796420

Install arsenic removal system

Purchase and install flow meter and associated equipment/programming and port; Excavate, install conduit, backfill and landscape

Install security fence and lockable gate around well house number 3

Rewire 6 wells generator plugs; Install new 100 amp wire generator, receptacles and wire system to manual transfer switch

Seal two wells

Purchase and install backup generator and equipment for well and reservoir

Upgrade SCADA to ensure safety and security for wells

Remove underground 10,000 gallon fuel oil tank to protect wells within the DWSMA

Seal municipal well #2 and remove pipe and pump so it will not be a dead line entry to pressure tank.

Provide second half of rent payment to landowner to allow city to implement nitrogen BMPs on field. Planting custom seed rye to scavenge up the residual nitrogen in the soil to keep it from getting into groundwater.

Irrigate its clarified effluent from Lime storage pond #6 instead of discharging to Mississippi River

Seal and grout 4 wells

Drill a new well and seal well #5

Purchase a GPS unit to verify unknown wells in the DWSMAs, verify and locate wells. Create inventory of wells within the DWSMAs to integrate into city mapping.